All-Terrain vs Crawler Load Charts: Configuration Differences
How outriggers, counterweights, crawler geometry, extensions and operating sectors change the way crane load charts must be selected.
All-terrain and crawler cranes may both be described with a single nominal tonnage, but that number is not sufficient for evaluating a lift. Their charts are organised around different support conditions, attachments and operating assumptions. Selecting the wrong table can invalidate every subsequent capacity calculation.
This guide explains the information to locate before comparing two machines for the same lifting task. It is intentionally manufacturer-neutral: the purpose is to make the selection process clear, not to reproduce or replace an original rated-capacity chart.
Step 1
All-terrain cranes: support configuration is central
For an all-terrain crane, check the exact outrigger extension and support condition, on-rubber versus supported operation where applicable, counterweight arrangement, boom or jib configuration and permitted operating sector. A table produced for fully extended outriggers cannot be assumed valid when a site limits the available outrigger spread.
Some manufacturers provide multiple counterweight or support configurations, including variable or asymmetric systems. These configurations must be matched to the equipment actually installed and the approved set-up conditions. The operating radius is measured from the relevant rotation centre, not from the outer outrigger pad.
Items to verify
- Confirm outrigger beam position and pad support.
- Verify counterweight and boom/jib configuration.
- Check the chart for the permitted working area or sector.
Step 2
Crawler cranes: boom system and configuration matter
Crawler charts often distinguish main-boom, fixed-jib, luffing-jib and additional counterweight or derrick arrangements. A crawler's rated capacity depends on the specific attachment combination, working radius, boom length, counterweight and applicable operating notes.
Some crawler installations may be able to travel with a load, but pick-and-carry operation must never be inferred from a normal stationary load chart. Track direction, ground level, permitted travel conditions and manufacturer-specific instructions can materially alter the allowable operation.
Items to verify
- Match boom and jib attachment tables exactly.
- Confirm any supplementary counterweight or derrick system.
- Use a travel-with-load chart only if the manufacturer expressly provides one.
Step 3
Why equal nominal ratings do not imply equal performance
Imagine two cranes with the same nominal maximum capacity. One is configured with a short boom and a small working radius; the other must reach around a structure with a longer boom, a jib or a different working sector. Their available capacity at the required geometry can differ considerably, even though the advertised machine tonnage is similar.
A useful technical comparison therefore fixes the required load, maximum radius, hook height, obstacle envelope and installation constraints first. Only then should the official configuration-specific tables for each crane be checked.
Items to verify
- Compare required lift geometry, not brochure tonnage.
- Keep the proposed crane configurations explicit.
- Check clearance separately from the rated-capacity assessment.
Step 4
Ground support and site constraints
Both crane families impose significant site loads, but through different supporting systems. An all-terrain crane transfers load through its configured outriggers or tyres, while a crawler normally acts through tracks. Neither configuration can be accepted without assessing the actual ground conditions and applicable support requirements.
Do not derive permissible bearing pressure from crane tonnage alone. Ground reactions, distribution, mats and allowable soil pressures require appropriate data and engineering checks. A crane with a suitable lifting chart can still be unusable because of access, assembly space, ground capacity or proximity to buried services.
Items to verify
- Verify lift location and assembly area.
- Request appropriate support reaction data.
- Separate lifting-capacity suitability from ground-bearing acceptability.